weird ROL problem...

[Tallon]

Hmm ok so I'm trying to make a plug for my rol panel I've extended
For some reason I cannot turn the 360 on with the button anymore, I have to press the eject button to turn on the console.

I've rewired it several times, with the original plug and a 9 pin plug.
I'm using IDE Cable, I seem to have bad luck whenever I use it.
It does light up, though, so I'm guessing it's ok to use this kind of wire -

So does anyone know which pin(s) on it actually power up the console?

[mdh16]

Seems it was touching those grounds had the same problem it was just that you probally made a mistake and acciedently touched the board to a ground source resulting in a shorted board.. mines i couldnt even connect a controller. just replace it .... theres no fix Fyi if want a power button use the grnd power activate pin on the power plug .