i was wondering if any one had a circuit diagram of....

shadowhacker · Post by **shadowhacker** » Fri Dec 23, 2005 3:38 pm

the six buttion sega genesis controller?

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Fri Dec 23, 2005 3:44 pm

do you mean how to hook it up to the genesis

most anything can be found out about a controllor by tracing leads with your multimeter

also try the sticky

Post by **Sparkfist** » Fri Dec 23, 2005 3:49 pm

If your planning to redesign or rebuild the controller this might help.

shadowhacker · Post by **shadowhacker** » Fri Dec 23, 2005 6:10 pm

i need a six buttion controller one though

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Fri Dec 23, 2005 6:35 pm

i told you already just use your multimeter and trace the button back to the chip

shadowhacker · Post by **shadowhacker** » Sat Dec 24, 2005 11:17 am

gah thats going to take awhile ll do it later today before the company comes over

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Sat Dec 24, 2005 11:24 am

actually it only takes like 5 minutes
set your multimeter to the ohms symbol and your good to go

shadowhacker · Post by **shadowhacker** » Sat Dec 24, 2005 11:32 am

ok i was going to do something compleatly diffrent can you tell me like you would tell a retard?

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Sat Dec 24, 2005 11:58 am

were did you get your multimneter i have a cheap radio shack one here how i do it

set the multimeter to the symbol for ohms

touch the two prongs together, your multimeter should go all the way up or beep, if it doesnt go all the way up there should be a knobv somewhere that you can adjust

now touch one prong to the button and another prong to the chip and repeat until the meter goes all the way up

Post by **gannon** » Sat Dec 24, 2005 12:01 pm

My question would be (it seems that everyone in this thread assumes the answer is yes), is "Do you have a six button controller already?"

shadowhacker · Post by **shadowhacker** » Sat Dec 24, 2005 12:08 pm

yes but i cut out the dpad to widen the controller but i cant soder on to the tiny connsetions so i was just going to remake the controller

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Sat Dec 24, 2005 12:14 pm

to solder onto the tiny connections all you have to do is scrape the green off or sand it until you can see some shiny copper

shadowhacker · Post by **shadowhacker** » Sat Dec 24, 2005 12:15 pm

yeah i have done that but it wont stick or hold

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Sat Dec 24, 2005 12:16 pm

you must not be doing it right then

sand the traces a little more and use some flux

shadowhacker · Post by **shadowhacker** » Sat Dec 24, 2005 12:17 pm

ok thaks turbo tax you may have just saved christmas!