snes carts

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Sat Sep 03, 2005 9:39 pm

mod

easier mod
wat do both of these mods allow me to do. will they both end up allowing me to play PAL games on my snes because the easier mod is basically done on my snesp and i am wondering if i can now play PAL games on it

soundwave · Post by **soundwave** » Sat Sep 03, 2005 11:25 pm

"Note! This mod will not allow you to play EUROPEAN/PAL games! These games differ not only in cartridge shape, but in display speed (PAL vs NTSC) and they have different ROMs. I have seen cartridge adapters available but given their price and availability, you might be better off to get another system."

dj-spuddy · Post by **dj-spuddy** » Sun Sep 04, 2005 4:28 am

Soundwave is correct, I live in the u.k and the games are much slower. I did not notice normally but once i played an ntsc game they about 30% faster.

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Sun Sep 04, 2005 9:05 am

ok thanks but if i put a switch in the first mod i could play european games right

dj-spuddy · Post by **dj-spuddy** » Sun Sep 04, 2005 12:12 pm

Yes that sounds right, But you never know.

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Sun Sep 04, 2005 12:15 pm

i think i'll go for it i just hope i dont copulate up my snesp
and in the mod do i just snip the lead and have a switch between it and ground so i can turn it on and off

dj-spuddy · Post by **dj-spuddy** » Sun Sep 04, 2005 12:22 pm

If the mod was unsuccessful you could allways put it back the way it was aslong as you write down what you de-soldered and where ect. I believe there is a special cartdridge slot the exists that is pal but connects into a ntsc snes. But i don't think it would disable the lockout.

Erm... i have no idea what to cut an attach but i'm sure you can figure it out, try asking other members.

EDIT: Actually the mod looks quite simple just remove pin 4 off and solder a wire to where the pin was then conect the wire to ground.

Above you can see what to do with the chip.