Hey guys, getting ready to desolder my PS2s controller and mem card slots so i can solder my controller board to the mobo and i was wondering what you guys recommended as the ammount of wattage the soldering iron should use when heating up the solder to desolder it...
peace in advance yo.
--Tony. <3
PS2 Desoldering
Moderator: Moderators
-
Haunted360
- Posts: 1000
- Joined: Sat Jan 30, 2010 12:22 am
- PSN Username: Haunted360
- 360 GamerTag: Haunted 360
- Location: Australia
- Contact:
Re: PS2 Desoldering
Hey,
350 Degrees Celsius is fine. Just do not hold it there (on the pin/solder joint) for too long, or you will burn out all the Flux and possible components on the board too.
The solder recommended, is Rosin Core Flux Solder. Un-leaded.
Thanks.
350 Degrees Celsius is fine. Just do not hold it there (on the pin/solder joint) for too long, or you will burn out all the Flux and possible components on the board too.
The solder recommended, is Rosin Core Flux Solder. Un-leaded.
Thanks.