No GC LID HELP

[Remocleus]

SO there are two switches that tell the gamecube the lid is closed. I want it to think its always closed. there are two blure wires going onto the circuit board with the switches on it, if i solder this wires together will it allow the disk to run without lid?

[Tibia]

Yes.

[Remocleus]

alright cool it worked

[NintendoRox]

you can also cut off the connector in the lid sensor, maybe extend it and solder on a slide switch
you can also solder the female connector out the lid sensor in case you ever need it :p