Portable Gamecube Worklog

[Curly]

I'm going to try to make a gamecube portable. I have made a n64 portable before but decided that the gamecube is better. The case will be made out of wood and a 9600 milliamp battery for extra play time XD. Also do u guys know of a locking device i could have for the lid at the back? I expect do be finished in about 12 weeks. Here's the designs so far...

The attachment Front.jpg is no longer available

Front.jpg (45.93 KiB) Viewed 5627 times

Back.jpg (50.11 KiB) Viewed 5627 times

[hawkeye2309]

cant wait to see it when its done

[thewise1]

You can use velcro or a powerful magnet, I suggest velcro because it won't mess up analog lines when it's near them.

[Curly]

Well here's what i've done so far...

And i have decided to make the gamecube portrait instead of landscape.

[Curly]

OH FFS!!!!!!!!!

Have done all the hard bits but accidently knocked off one of those TINY resisitors!

Or is it becuase i need one of these cables?

Kasar said u should use the tiny board inside the cable, do i need that?

[thewise1]

There is no board inside the composite cable, just use wires. And try to get that resistor back on.

[Curly]

what about this thing though?

Thx Kasar for the picture

[zenloc]

It doesn't matter that you knocked it off. that's only used for rgb. And since your not using that it will still work fine with composite

[Curly]

So i don't need one of those boards from the cable?

[Basement_Modder]

Those boards in the A/V cable is only present in PAL peripherals, and even then is not needed on most screens.