Is This A Good NESp case?

josh · Post by **josh** » Fri Jul 14, 2006 4:09 pm

http://www.pactecenclosures.com/Plastic ... B_2AA.html
Its For Sample...
Is it a good NESp case?

Post by **CronoTriggerfan** » Fri Jul 14, 2006 4:16 pm

I have that same case, and I can honestly say that it will be a VERY tight fit. Like, G-Force tight. It can be done, but you better have serious soldering, cramming, and hot gluing skills.

CTFan

josh · Post by **josh** » Fri Jul 14, 2006 4:19 pm

ok then,
then what case should i use?

Post by **CronoTriggerfan** » Fri Jul 14, 2006 4:29 pm

Radio Shack sells a nice project box that will work for you. I used it on my NESp, so I can personally recommend it. It's a tad thick for some people's taste, but you can always just grind it down with a dremel. You can get the box at any standard Radio Shack, they usuall only have a few for sale, and there's only one that's not rediculously large or rediculously small, so it should be relatively easy to find.

You could always go the custom route, though, and franken up a case. Just a though.

CTFan

josh · Post by **josh** » Fri Jul 14, 2006 4:42 pm

ok.
i also have a question about the controler,
how do i cut up the nes controler and using solder and wires put wires connecting the buttons from the nes controler to the noac controler?

Post by **gannon** » Fri Jul 14, 2006 7:48 pm

I made a NOACp case with the black version of that. Hipgear screen + cut up controller + 2x2AA battery cases. I accidently tossed it out while cleaning though