IC in the Controllers

nos_slived · Post by **nos_slived** » Sun Jun 05, 2005 7:49 pm

Flux helps you solder. It is usually sold in a tube near solder and solderring tools.

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Mon Jun 06, 2005 7:11 am

i use lemon juice

seriously

*o* · Post by ***o*** » Mon Jun 06, 2005 3:22 pm

does it work

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Mon Jun 06, 2005 9:27 pm

yeah my bro told me to use it and it helps a hell of a lot

oh yeah i wired the controller and cut it down so it is pretty small

shmagoogin77 · Post by **shmagoogin77** » Tue Jun 07, 2005 6:17 am

pics?

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Wed Jun 08, 2005 11:30 am

mom took the camera to brown university

cennar · Post by **cennar** » Sat Aug 27, 2005 4:19 pm

i hate tact switchs.. why not just chop and relocate... saves time space and most of the time conforms to the case... short of that you could just desoulder the ic and mount it close to the snes bord as you can. the switches are a prefrance thing any ways

usbcd36 · Post by **usbcd36** » Sat Aug 27, 2005 5:08 pm

I agree with cennar, especially if you are doing a portrait-style portable. Just use the original control board, if you need to chop it, it's probably worth it anyway. Some systems don't even need the chopped controller (ex: N64 boomerang controller has chip, D-pad, analog stick and other buttons all on different boards connected by wires.)

shmagoogin77 · Post by **shmagoogin77** » Sat Aug 27, 2005 5:45 pm

why was this old thread brought up?

usbcd36 · Post by **usbcd36** » Sat Aug 27, 2005 6:03 pm

Ah, I didn't even realize. Cennar brought it up apparently. Are the mods sleeping or something? This is like the fourth time todayâ€¦

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Sat Aug 27, 2005 8:42 pm

its because i put this in the sticky

usbcd36 · Post by **usbcd36** » Sat Aug 27, 2005 8:44 pm

Ah, that would do it.