Splitting Intec GCN battery.

khaag · Post by **khaag** » Fri Dec 29, 2006 1:44 pm

Does anybody know how I could split the intec gamecube battery without altering anything, other than the location of the cells? Here is a picture of the battery in question:

I drew a line where I'd like it to be split.

Thanks in advance,
khaag

timmeh87 · Post by **timmeh87** » Fri Dec 29, 2006 2:14 pm

it depends if thats a 5 or a 10 cell pack. i cant tell from the picture. but it kinda looks like theres only 5 long cells in there?

if it is indeed 10 cells, with a division along that line you drew, then i guess you are going to have to take off the plastic to see whats inside. it all depends on how the cells are wired up inside.

if its only 5 cells... well. you cant cut them in half

khaag · Post by **khaag** » Fri Dec 29, 2006 2:42 pm

ill go check how many cells there are.

ShockSlayer · Post by **ShockSlayer** » Fri Dec 29, 2006 4:23 pm

I believe thats Interact, and unless its a gamecubeP. I would'nt use those.

SS

khaag · Post by **khaag** » Sat Dec 30, 2006 2:07 pm

Nope its not interact, it's intec. And why shouldn't I use it if its not for gamecube?

Post by **Skyone** » Sat Dec 30, 2006 2:45 pm

Looks like 10 cells.

Unwrap the pack's skin (that green plastic holding it all together) and you'll see the interconnects. You can easily relocate that in a few different ways.

Post by **marshallh** » Sat Dec 30, 2006 3:31 pm

Yep, it's 10 cells.

10 x 1.2v = 12v

khaag · Post by **khaag** » Sat Dec 30, 2006 7:40 pm

Skyone wrote:Looks like 10 cells.

Unwrap the pack's skin (that green plastic holding it all together) and you'll see the interconnects. You can easily relocate that in a few different ways.

Are the interconnects a cardboard looking thing on the battery terminals?