DS dissasembly

cowsgoquack101 · Post by **cowsgoquack101** » Wed Jul 05, 2006 9:44 am

I just got a new shell for my DS and I have to take it apart to put it in the new case. Can anyone please tell me how?

vskid · Post by **vskid** » Wed Jul 05, 2006 9:49 am

I haven't taken one apart, but under the rubber pads and stickers is where most of the screws are usually hidden. For the stickers, just feel for an indent and poke a hole through when you find one. If I had a DS I could help more, by taking it apart myself and telling you how.

Harshboy · Post by **Harshboy** » Wed Jul 05, 2006 10:42 am

I took like 1 sec to do that. I sold my DS so i cant show you but on the bottom is the jist of it. You need to get the one under the battery! And theres one in the GBA slot. You will need a very small flat head screwdriver for this.

cowsgoquack101 · Post by **cowsgoquack101** » Wed Jul 05, 2006 11:26 am

No I've already done that I need to seperate the screens to put ti in the new case. I was looking at it and it's a ribbon cable and a power wire going to the top screen.

vb_master · Post by **vb_master** » Wed Jul 05, 2006 11:29 am

You need to tap out the hinge parts.

cowsgoquack101 · Post by **cowsgoquack101** » Wed Jul 05, 2006 5:06 pm

Nevermind everyone I got it finished! I'll post pictures of it. Later.

Indigno · Post by **Indigno** » Thu Jul 06, 2006 11:15 am

Were you trying to fit a phillips/ flathead into the nintendo screws or am I misuderstanding what you were asking?

vb_master · Post by **vb_master** » Thu Jul 06, 2006 11:50 am

Indigno wrote:Were you trying to fit a phillips/ flathead into the nintendo screws or am I misuderstanding what you were asking?

I think he couldn't figure out how to get the hinges off.