Plastic/bent aluminum method-aluminum=???

Post by **CronoTriggerfan** » Tue Jun 13, 2006 9:55 pm

I'm considering using styrene and bent aluminum for my next portable case; however, I HATE working with that aluminum, and Ben's acrylic wall method is quite pricy. Does anyone know what else one could use to cover the siding, while still being sturdy and professional looking?

Thanks,
CTFan

G-force · Post by **G-force** » Tue Jun 13, 2006 10:54 pm

Well.. I came up with a neat method that uses channel aluminum for the sides and plexiglass for the top and bottom. It was very sturdy and didn't cost too much (the channel aluminum was kinda pricy though)
If you're interested in this I could show the cases I made.

Post by **CronoTriggerfan** » Wed Jun 14, 2006 9:23 am

Could you? This is quite intriguing....

CTFan