Power Joy

Post by **gannon** » Sun Jun 20, 2004 11:24 am

I just found out from the power joy suppliers that the Power Joy II that I use is now longer available in the US, and only available in PAL.
Also, here's a picture of it.

Post by **Sparkfist** » Sun Jun 20, 2004 2:02 pm

Whats that mean as far as performace, board layout, or complexity modding are conserned

Post by **SpongeBuell** » Sun Jun 20, 2004 3:12 pm

The European format is PAL, which is not compatible with the NTSC setup in the US

Post by **gannon** » Sun Jun 20, 2004 3:15 pm

yeah, unfortunately. I like the power joy II a lot also. The entire board is about the size of a nes controller too.

someone · Post by **someone** » Sun Jun 20, 2004 9:52 pm

yes its a good one.

Guest · Post by **Guest** » Fri Jul 02, 2004 11:28 pm

I have a NES in an N64 controller and on the board you can set whether it is PAL or NTSC by replacing a clock-signal-generator-thing and jumpering a couple of points.

Post by **gannon** » Sat Jul 03, 2004 1:15 am

That would be quite nice if it works with the pal power joy II, then I suppose I could still get a new one.

TuzenTCA · Post by **TuzenTCA** » Sun Jul 04, 2004 9:32 pm

At my local mall you can buy the Super Fun Joy things for about 23 bycks or so. They are the models I and II. They are being sold at a stand in the middle of the food court. I like my Jakks Atari Better though.

vb_master · Post by **vb_master** » Mon Jul 05, 2004 7:27 am

At the mall I go to, the Super Joy is located near the food court, next to a hermit crab stand. Best of all, no body's ever there.