Some Good Plastic

ValiantVenality · Post by **ValiantVenality** » Wed Mar 01, 2006 7:40 pm

Where would I find some good plastic that ben uses in his book? And would it be thin?

Ghost2520 · Post by **Ghost2520** » Wed Mar 01, 2006 7:49 pm

Are you talking about the engraving plastic that he speaks of for his NES project? It was a serious ***** to find that stuff in my town! I seriously drove around for 4 hours and spent some time on the phone. I finally found a guy who owned a business in his garage selling the stuff. It cost me 25 bucks for 3 sheets 12 inches by 12 inches.

The stuff is 1/16th inches thick just like the book says. I'm going to end up putting some plexi under it because it just feels too thin.

Fanboy · Post by **Fanboy** » Thu Mar 02, 2006 7:52 am

The guy who built the Cherry Bomb NESp (scherubino) gave me a link to a plastic retailer near me, but I'm on the EC... Also, Valiant... I told my parents that the NESA was stolen, so they put a bid on a NeoPocket Fami (they never tell me their logic)... This means, basically, hold off on building that NES, because I don't wanna end up paying 140$+ for two seperate NESps... Keep working on yours though, show me it when you're done!

PS: The NeoPocket Fami comes with a converter...