power scematic or picture

new york cheech · Post by **new york cheech** » Mon Jul 18, 2005 7:36 pm

i was wondering if anyone could post a scematic or a picture of the wiring for the power with 12v dc power and a 12v-3v converter.

daguuy · Post by **daguuy** » Mon Jul 18, 2005 7:58 pm

new york cheech · Post by **new york cheech** » Mon Jul 18, 2005 8:52 pm

so just combine all the negatives into 1 wire and then just split it three ways into the board?

nos_slived · Post by **nos_slived** » Mon Jul 18, 2005 8:55 pm

7.2V-35V directly to the 12V pin, and split the 3V into the 3.3V pins.

daguuy · Post by **daguuy** » Mon Jul 18, 2005 9:14 pm

new york cheech wrote:so just combine all the negatives into 1 wire and then just split it three ways into the board?

negative is ground, you can combine and split them as much as you want

new york cheech · Post by **new york cheech** » Mon Jul 18, 2005 9:17 pm

what 7.2v?

nos_slived · Post by **nos_slived** » Mon Jul 18, 2005 9:26 pm

Anything from 7.2V to 35V can be used to power the 12V line.

daguuy · Post by **daguuy** » Mon Jul 18, 2005 9:27 pm

7.2v from the 7.2v battery, unless you're using a screen that takes a different voltage

nos_slived · Post by **nos_slived** » Mon Jul 18, 2005 9:32 pm

Of course most 3V car adaptors need atleast 10.8V.