controller expansion port question!!!

*o* · Post by ***o*** » Fri Jul 01, 2005 6:13 am

which pins on the expansion slot on the controller lead to the pins on the top?

i am rtying to hardwire in an expansion pack......but i need to know this first....

daguuy · Post by **daguuy** » Fri Jul 01, 2005 9:23 am

it shouldn't be too hard to trace it and find out

*o* · Post by ***o*** » Fri Jul 01, 2005 3:44 pm

there are 4 rows of pins on the top and only 2 rows of contacts....so i dont know

Link89 · Post by **Link89** » Mon Jul 04, 2005 11:29 am

Could you explain this a little more. I have extended the expansion slot on the controller before. If your talking about what i think you are then you need all of them to still have a contact to the copntroller. I think you already know the answer.

*o* · Post by ***o*** » Mon Jul 04, 2005 3:53 pm

i was womdering which pins on the top of the board correxponded to the contacts in the slot.....then i saw the numbers!!!! the pins are number!!!!

having a rumblr pack in an n64 wouldnt damage it would it?

S q u e e ! · Post by **S q u e e !** » Mon Jul 04, 2005 10:36 pm

It could jostle (sp?) the cart slot around quite a bit depending on where you have it.

nos_slived · Post by **nos_slived** » Mon Jul 04, 2005 11:25 pm

I would suggest using some long wires so you can attach it to your arm. The shaking motion could cause some problems.

*o* · Post by ***o*** » Tue Jul 05, 2005 1:03 am

oh.....i guess ill put it in on a switch and if i dont like it just remove the switch