how do you split a gc controller?

Metroid fan · Post by **Metroid fan** » Fri Apr 22, 2005 9:29 pm

I would very much like to know

goodie · Post by **goodie** » Sat Apr 23, 2005 7:16 pm

Cut the controller's circuit board in half. Use wires to reconnect the broken traces together.

Metroid fan · Post by **Metroid fan** » Sat Apr 23, 2005 8:43 pm

thanks

Post by **Gamelver** » Sun Apr 24, 2005 8:16 am

or if you happen to have two controllers and space in your case, just take apart one controller, cut it in half, and wire that half to the appropriate places on the other controller

...(trust me, this makes it A LOT easier to wire

....)

Metroid fan · Post by **Metroid fan** » Sun Apr 24, 2005 9:56 am

cool thanks a lot

Mr. Cool · Post by **Mr. Cool** » Sun Apr 24, 2005 12:49 pm

Use IDE wire

BloodNess · Post by **BloodNess** » Mon May 23, 2005 1:45 pm

Hey Gamelver could you explain that better. I didn't quite catch that. About the controller. Also how do you make the gcp to be a one player system. or have full 4 players w/o having five controllers...

gamefreak301 · Post by **gamefreak301** » Thu Jun 02, 2005 9:44 pm

You would only need three more controllers, since your using one slot already for the buttons on the GCP (You cant have two controllers in one port!)

zenloc · Post by **zenloc** » Thu Jun 09, 2005 8:56 am

can someone post some pics showing where you split the controller??

i can't really find a way to split it without damageing the circiuts??

chodges84 · Post by **chodges84** » Thu Jun 09, 2005 9:02 am

enloc,

I think you have to cut through the circuits and then rejoin them using wire. Try and cut it in a straight line where there are no resistors.

Gelmever or someone had better confirm that though, as I've never taken a GC controller apart. But if I did that's what I'd do.