Chopping My '95 SNES

cowsgoquack101 · Post by **cowsgoquack101** » Fri Nov 25, 2005 6:57 pm

Well, if you could cut it wouldn't someone on this froum have done it before? Thats the way I look at it.

SNESguy · Post by **SNESguy** » Sun Nov 27, 2005 4:24 pm

My advice is this:

Only cut where you see large amounts of metallic ground strips. (AKA the sides between the cart connector and the front.)

I did this personally, and I only trimmed a few millimeters off close to the regulator and the opposing side.

There are few, if NO traces at all where there the grounding strips are.

DO NOT trim any board on the front (where the controllers connect), there are lots of little traces that connect the controller ribbon cable.

Hope this helps.