3.3V

warbaby · Post by **warbaby** » Mon Jun 13, 2005 2:02 pm

whats the range in which the 3.3 v line can still operate... ive run a gagitillion C's in parallel on that line... 3.18 V it came to, nothing... then tried DC-DC adapters set at 3 volts... nothing... any ideas?

daguuy · Post by **daguuy** » Mon Jun 13, 2005 2:05 pm

the range it will work with depends on which model you have. maybe it fried

nos_slived · Post by **nos_slived** » Mon Jun 13, 2005 4:49 pm

Did you have the right ground for it?

Post by **Gamelver** » Mon Jun 13, 2005 5:15 pm

if everything's wired up right and it's still not working, then I'm willing to bet that your N64 is fried

.....I know for a fact that the 3.3v line can take 3v with no problems (well, a few, but it should work anyway)...once again, if you're SURE that everything's wired up correctly and it STILL doesn't work...try getting a new N64. actually, I forgot to mention that you should try the thing where you take out the expansion/jumper pack, turn the system on for 10 seconds, turn it off, and then try it again with the expansion/jumper pack. If that doesn't work, then either your expansion/jumper pack is fried or your N64 is

....

warbaby · Post by **warbaby** » Mon Jun 13, 2005 7:38 pm

thx... i always know i can find sum insite here...

id marry this website/webhost if i could.

ill get another n64 if i have to, but i had a hell of gettin it open, used a hack saw and a molten pen. maybe i wired my ground up incorrectly, i was under the impression i could run them all thru the same wire... my LED goes up no prob, the 12 V circuit workin pretty good...

ill see if i can get an image... nvm, webcam is dirt... ill draw.

srry bout the drawin, i dont think i passed grade 4 art...

nos_slived · Post by **nos_slived** » Mon Jun 13, 2005 8:07 pm

It's right.

warbaby · Post by **warbaby** » Mon Jun 13, 2005 8:58 pm

LED not comin on any more, after i tried that 'run 10 secs with no jumper pack'... thing does fry easy. tried with jumper and expansion packs. maybe ill try again with a diff mobo..

i juss dont understand, prior to frying it, it ran fine off of wall juice, but as soon as i rigged it up to batteries te 3.3 V line woodnt start up. was it becuz i was using an expanion pack, or DK 64?

daguuy · Post by **daguuy** » Mon Jun 13, 2005 9:04 pm

N64s fry from just about everything. you could give it a dirty look or say "boo" and it will fry. be paranoidly (is that even a word?) careful to not bump it, jerk it, or anything else like that

*o* · Post by ***o*** » Mon Jun 13, 2005 11:52 pm

i havent had a problem with frying mine have been fine

daguuy · Post by **daguuy** » Tue Jun 14, 2005 9:07 am

you probably have one of the tougher models

benheck.com Forums

3.3V

>_<