help with screen wiring
Moderator:Moderators
-
- Posts:9
- Joined:Mon Nov 07, 2011 12:35 am
so in my quest to build a n64p with very little technological experience, ive recently acquired and dissessambled a portable DVD player, ive located the video input on the circut board, but i don't know how to wire it to an N64, the 5 inputs on my screen are labeled GND(ground i presume), SCL, SDA, +5V, +3.3V, i can also post a picture if you need one to help, thank you in advance for your help
- evilteddy
- Portablizer
- Posts:423
- Joined:Tue Mar 25, 2008 2:11 am
- 360 GamerTag:Kirren of Smeg
- Steam ID:kizzinator
- Location:Newcastle, Australia
Re: help with screen wiring
SCL and SDA would usually refer to the two lines in the i2c serial protocol. Obviously the others would be for the power. If the silkscreening is accurate it seems that this wouldn't be where the video input is.
-
- Posts:9
- Joined:Mon Nov 07, 2011 12:35 am
Re: help with screen wiring
so what kind of stuff should i be looking for as the video input?
- evilteddy
- Portablizer
- Posts:423
- Joined:Tue Mar 25, 2008 2:11 am
- 360 GamerTag:Kirren of Smeg
- Steam ID:kizzinator
- Location:Newcastle, Australia
Re: help with screen wiring
Trace where the RCA plugs go. Assuming its composite video then follow the yellow RCA plugs.