So I bought a ps2 screen (intec)
and I took it apart and everything. But when I went to reconnect everything, I realized that I didn't remember where to put the wires!?!?
There are only 4 wires I need help with.
And this is where the wires need to be connected to.
I KNOW THIS IS VERY HARD TO FIGURE OUT, BUT i have tried everything and desperately need your help!
NEED HELP RECONNECTING SCREEN!!!!
Moderator:Moderators
- andrewdorsey
- Posts:183
- Joined:Mon Dec 01, 2008 2:49 pm
- Location:hmmmmmmm
Re: NEED HELP RECONNECTING SCREEN!!!!
did you ever find a pin out of your screen..iv got the same problem
-
- Posts:1000
- Joined:Sat Jan 30, 2010 12:22 am
- PSN Username:Haunted360
- 360 GamerTag:Haunted 360
- Location:Australia
- Contact:
Re: NEED HELP RECONNECTING SCREEN!!!!
Look at the two board. See if you can figure out what pin goes where. May it be voltage, and ground. That is less 2 wires to deal with. Ground is the EASIEST to find because it is usually the MAIN part of the PCB. It is a solid copper line all around the board, at screw posts etc...
You have to try and figure out the links. IE: follow the traces...
Good luck!
You have to try and figure out the links. IE: follow the traces...
Good luck!
Re: NEED HELP RECONNECTING SCREEN!!!!
Could you post a pic using a macro or a flatbed scanner?
The screen printing on the board may help us figure it out.
The screen printing on the board may help us figure it out.