i know what your going to tell me use a multi-meter but i can't because i don't have a working ps3 psu to test it with so can someone kindly tell me
i searched every where i only found the ones for 3 and 5 pins
thanks
4 pin ps3 powersupply pinout
Moderator:Moderators
Re: 4 pin ps3 powersupply pinout
seriously i can't believe nobody on the ENTIRE internet know these pinouts..it would help me out a lot if someone could please help me
Re: 4 pin ps3 powersupply pinout
I can't believe you think everyone on the internet has read this thread, and need a pinout for something that you don't even have. You can also use a DMM for more than checking voltages.
You could trace them back to tell what they are. Based on how the 3 and 5 wire models are setup with Ground, 5vsb and PS_ON, it's probably the same way but has either 2 x Grounds or 2 x 5vsb lines, which could be checked easily enough if you used a DMM to check for 2 pins that are connected, or just looked at it for a bit. You'll get the Ground(s) figured out for sure, then the 5vsb would most likely be the heavier of the remaining traces with PS_ON being the only one left at that point.
You could trace them back to tell what they are. Based on how the 3 and 5 wire models are setup with Ground, 5vsb and PS_ON, it's probably the same way but has either 2 x Grounds or 2 x 5vsb lines, which could be checked easily enough if you used a DMM to check for 2 pins that are connected, or just looked at it for a bit. You'll get the Ground(s) figured out for sure, then the 5vsb would most likely be the heavier of the remaining traces with PS_ON being the only one left at that point.
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.
Re-mappable Wireless 360 Controller - The CGnome
Re-mappable Wireless 360 Controller - The CGnome