Portable Gamecube Case

[Archon276]

I was thinking of using a zn-40 or zn-45. Which one would work better or are there any that might fit it better?

[gamer255]

ZN-40 is too small
ZN-45 would work better but you might need an extension like SS did with the JB-55

[Archon276]

Kool.

So I'm actually planning on using the ZN-40 for a snes and n64 portable and the ZN-45 for the Gamecube portable.

[gamer255]

Cool can't wait to see some progress.
The ZN-40 for the N64 is a tight fit but it'll work.
The ps1 screen needs to be trimmed alittle to fit in the ZN cases if I'm correct.

[Archon276]

before i start working on these of course im gonna need a little cash but my first project is a controller mounted monitor for the xbox 360 similar to what they came out with for the ps2.

[Mr BadWrench]

too bad the ASCII gamecube keyboards are so valuable.



theres plenty of room in there and half the work is done.

[JariV]

The ps1 screen needs to be trimmed alittle to fit in the ZN cases if I'm correct.

Yup, but if you LED mod it you can just cut the top off

[hailrazer]

The ps1 screen needs to be trimmed alittle to fit in the ZN cases if I'm correct.

Yup, but if you LED mod it you can just cut the top off

No need , it fit's with very little trimming :

[Archon276]

thanks for that pic its going to help.