I does has a 3rd party N64 controller.... You gotz the moneys, I gotz the stuffs.Mario wrote:I still need...an N64 controller (3rd party)
Oh, and lookin' good. How far will the N64 stick out from the top and bottom of the screen?
Moderator:Moderators
I does has a 3rd party N64 controller.... You gotz the moneys, I gotz the stuffs.Mario wrote:I still need...an N64 controller (3rd party)
Definitely more than usual. Not, much, though, but that's why the flanks will be so thin.jjhammerstein wrote:Usual buttons stick out what, 3/8cm?
How much button is there outside of the case?
Well, I don't have any money yet. I hope to sell some DVD burner laser diodes to Palmer. Perhaps I can buy it from you then. How small is the board inside?vskid wrote:I does has a 3rd party N64 controller.... You gotz the moneys, I gotz the stuffs.Mario wrote:I still need...an N64 controller (3rd party)
Oh, and lookin' good. How far will the N64 stick out from the top and bottom of the screen?
They're bolted on tightly, with washers, and the plastic backing will be screwed into it. It'll be strong, don't worry.ShockSlayer wrote:Controller flanks are very win, but these look very...uh...unstable. Small, really. I hope they don't cause problems!
SS
Chapel wrote:Ah shucks, I was really hoping to make an SNES encased in a 19 pound glob of hotglue and duct tape.
However price may go up.Mario wrote:Don't forget, this portable is to sell. I'm going to be looking for around $350.