seperating the screen from the controller on a hip gear scre

monkeyman · Post by **monkeyman** » Sat Mar 12, 2005 4:51 pm

help!!!!!!!!!!!

ive unscrewed the controller and screen sections, and opened the controller, i see the wires going to the screen, and im ready to cut them, but i cant figure out how to seperate the controller from the screen, at the part where it can swivel and lock in. Do i have to literally cut the controller at this place, or is there a way to seperate the screen and the controller?

Also, i was told that you can just cut the wires going to the screen section, and sodor video in, audio l and audio r in, and dc power in (so the screen can be multipurpose), can anybody tell me which colour wire going from the controller board to the screen is for which function, i looked at ladyada's forum, but it was talking about pin#'s (im a newby

) and i dont want to screw this project up.

Thx in advance!!

Post by **Sparkfist** » Sat Mar 12, 2005 5:46 pm

Take a small flathead screw driver and pry at the seem for that hing. As for the pinout of the screen, do a search for it or search for post by Ladyana (you'll want the first two or so).

HK-47 · Post by **HK-47** » Sat Mar 12, 2005 6:39 pm

Sparkfist wrote:Take a small flathead screw driver and pry at the seem for that hing. As for the pinout of the screen, do a search for it or search for post by Ladyana (you'll want the first two or so).

1 its ladyada,
2 theres a link to the pinout in the sticky at the very top of the forum.