Simple case making
Moderator: Moderators
-
madc0w
- Senior Member
- Posts: 1912
- Joined: Sun Apr 24, 2005 7:40 pm
- Location: In the ghetto of Larchmont! A HALF-A-MIL HOUSE IS GANGSER!
- Contact:
Simple case making
I figured out a fairly simple way of making cases, that feels and looks ok actually. It can be adapted to any thickness really. The case is made out of a square made from four 90 degree pvc bends and 1/2 inch PVC, then two peices of plastic with small grooves cut in the corners for the bends, since they are slightly thicker. The roundness of the pipe makes for a fairly confortable handle. Any comments/suggestions/complaints?