ZENLOC INSPIRED ME TO TRIM MY PUBES
AND SO CAN YOU
lets trim a...
Portable cUBE
Top side - red is the data line. Everything else can go. Controller only needs data, 3.43v, and ground. 3.43 can come from anywhere, and data will come from the red via. Blue marks where you can cut.
Bottom side - red is data again. The black chip needs 3 things: ground(black), data(red), and via(pink). Thats it. Everything else can be ripped off. X marks what is NOT needed on the board. The Green area vias are where you will wire Memory card A Yellow line is the where you can cut Ground on the chip is the top left prong FYI.
*****PLEASE NOTE, I MADE A MISTAKE ON THE ABOVE PICTURE AND HAVE NOW FIXED IT (should be pretty obvious)
DISCLAIMER: BEFORE TRIMMING YOUR PUBES, I AM NOT RESPONSIBLE FOR ANY PERMANENT OR LONG TERM DAMAGE DONE! TRIM WITH CAUTION.
THIS GUIDE IS STILL A WIP. FURTHER TESTING WOULD BE IDEAL, BUT IF YOU FOLLOW THOSE TWO PICS, YOU SHOULD BE OKAY.
CREDITS TO THE ALMIGHTY ZENLOC FOR THIS AMAZING TRIM JOB
TRIM YOUR PUBES!!!!!!!!!!!!!!
Moderator:Moderators
Last edited by Tchay on Sun Apr 03, 2011 1:34 pm, edited 1 time in total.
- hidiosoman
- Posts:88
- Joined:Fri Jan 08, 2010 8:44 pm
Re: TRIM YOUR PUBES!!!!!!!!!!!!!!
I thought your account was hacked at first...
But this information is VERY useful! Thanks Tchay and Zenloc!!
But this information is VERY useful! Thanks Tchay and Zenloc!!