No GC LID HELP
Moderator:Moderators
SO there are two switches that tell the gamecube the lid is closed. I want it to think its always closed. there are two blure wires going onto the circuit board with the switches on it, if i solder this wires together will it allow the disk to run without lid?
-
- Posts:14
- Joined:Sun Feb 14, 2010 12:09 pm
- 360 GamerTag:DragoonX6
- Location:The Netherlands
Re: No GC LID HELP
you can also cut off the connector in the lid sensor, maybe extend it and solder on a slide switch
you can also solder the female connector out the lid sensor in case you ever need it :p
you can also solder the female connector out the lid sensor in case you ever need it :p