help with screen wiring

austinphilp · Post by **austinphilp** » Mon Dec 12, 2011 7:19 pm

so in my quest to build a n64p with very little technological experience, ive recently acquired and dissessambled a portable DVD player, ive located the video input on the circut board, but i don't know how to wire it to an N64, the 5 inputs on my screen are labeled GND(ground i presume), SCL, SDA, +5V, +3.3V, i can also post a picture if you need one to help, thank you in advance for your help

evilteddy · Post by **evilteddy** » Tue Dec 13, 2011 2:39 am

SCL and SDA would usually refer to the two lines in the i2c serial protocol. Obviously the others would be for the power. If the silkscreening is accurate it seems that this wouldn't be where the video input is.

austinphilp · Post by **austinphilp** » Thu Dec 15, 2011 5:35 pm

so what kind of stuff should i be looking for as the video input?

evilteddy · Post by **evilteddy** » Thu Dec 15, 2011 6:16 pm

Trace where the RCA plugs go. Assuming its composite video then follow the yellow RCA plugs.

benheck.com Forums

help with screen wiring

Re: help with screen wiring

Re: help with screen wiring

Re: help with screen wiring