Simple SNES IC question
Moderator:Moderators
When wiring a controller using a 520B (Original SNES controller IC) do you need any resistors on the tact switches?
Re: Simple SNES IC question
lemme check. *checks the book*
you need 16 10k-ohm, 1/4 watt resistors.
you need 16 10k-ohm, 1/4 watt resistors.
AfroLH wrote:Yeah well Alcohol adds a little bit of sexyness in my eyes, but I dont drink it all the time.HotDog-Cart wrote: Also, the codename stuff adds a little bit of sexyness, in my eyes.
SpongeBuell wrote:As proof, I offer this picture of a monkey on my head.
Re: Simple SNES IC question
That's for using two 4021s. Not for using one discontinued original 520B (THe IC in the original SNES controllers).
Re: Simple SNES IC question
Come on, someone's gotta know.
Re: Simple SNES IC question
well, I said that too.
Re: Simple SNES IC question
Did you ground on the back?
- Triton
- Moderator
- Posts:7397
- Joined:Mon May 24, 2004 12:33 pm
- 360 GamerTag:triton199
- Steam ID:triton199
- Location:Iowa
- Contact:
Re: Simple SNES IC question
yep, the ground trace and the cord wires are on the back
Visit us at Portablesofdoom.org