I'm working on a pretty basic Platstation portable, with the original cases intact like Life of Brian's, and I have two questions.
The first being, can I just connect the power source to the ground and +7v on the PSone board, and will the PSone Screen still recieve power via the screen being attached to the PSone?
My second being, how would one go about rewiring the controller with tact switches? It's not like a NES controller where there are two traces and the connections are just grounded out! Help!
Need Somw Help on a PSonep
Moderator:Moderators
- thewise1
- Portablizer Extraordinaire
- Posts:1413
- Joined:Sun Jan 04, 2009 8:18 pm
- Location:Sitting on my pile of authentic minnesota dirt
Re: Need Somw Help on a PSonep
the first question should be yes because the power is jack is connected to the screen and the console.
Re: Need Somw Help on a PSonep
If you're using a Dualshock controller you can solder to the pins shown here (under the black clip on the top left)
- themadhacker
- Senior Member
- Posts:2670
- Joined:Wed Aug 06, 2008 7:53 pm
- Location:ohio
Re: Need Somw Help on a PSonep
that's odd about dualshock's
I have opened a lot of them. It seems that half have the buttons on a normal pcb, and the other half on those plastic filmy pcbs.
I have opened a lot of them. It seems that half have the buttons on a normal pcb, and the other half on those plastic filmy pcbs.
rest in peace, Ronnie James Dio! \m/
- blaze3927
- Portablizer
- Posts:1114
- Joined:Mon Dec 08, 2008 6:14 am
- 360 GamerTag:notjames
- Location:Australia
- Contact:
Re: Need Somw Help on a PSonep
it s not that odd too have more than one revision of a controller. how man Nintendo 64 revisions are there?themadhacker wrote:that's odd about dualshock's
I have opened a lot of them. It seems that half have the buttons on a normal pcb, and the other half on those plastic filmy pcbs.
Australian Kaillera server
[url]hhttp://i56.tinypic.com/ncb0wi.gif[/url]
[url]hhttp://i56.tinypic.com/ncb0wi.gif[/url]