Nes controller Fc Twin Help

[Clumsyjunkie]

Anyone have a Wiring Diagram so i Can wire a Nes Controller into my Fc Twin Controller

[argelfraster]

You are trying to wire one controller into the other?
why?

[Clumsyjunkie]

Cause I hate The Fc Controllers The Buttons Don't work to Good and I Play more Nes on it Then Snes Plus I got like 20 snes & Nes controllers

[metalcookie]

well, i guess you can try and shrink the fc twin controller motherboard and fit it into the nes controller. from there it's just a matter of rewiring the buttons

[Ace_1]

No need to shrink the board. Just take an official NES controller, take out the cord and solder the wires as follows where the FC Twin controller's wires are soldered(each hole is labeled):

White: FC Twin VCC
Brown: FC Twin GND
Yellow: FC Twin DO
Orange: FC Twin PL
Red: FC Twin CLK

That's it! If this combination doesn't work, swap the red and yellow wires around.

[SATAN7782]

Im trying to make my fc twin controller pc by conecting it to a db25 conector. I have the wiring plans to do it with a regular snes controller but did not want to sacrifice an original controller. Only the wires are different colors in the fc twin controller and there is an extra wire. Could anyone help with this? I need the to know wich wires = the snes controller wires and what to do about the extrea one?

[SATAN7782]

What about the blue wire? do you just not connect that one? Im making a fc twin controller into pc by conecting it to a db25 conector. I have the plans to do it with a regulat snes controller but do not want to sacrifice an original controller.