How many fans can you put in an Xbox.
Moderator:Moderators
I'm working on the cooling for my 360 Laptop project. My current idea is to cut the stock GPU to fit over the CPU and place 70mm fans over both. Then I would put some 40mm fans on either side and place some plastic around them for a wind tunnel. As of now, I would like two fans blowing in on the left side behind the DVD Drive, the two fans blowing down on the GPU and CPU, with another four blowing out on the right side. My question to you all is; can I wire eight fans into this box?
Re: How many fans can you put in an Xbox.
In addition to USB speakers and possibly a keyboard.
- humakabula1
- Posts:728
- Joined:Sun May 30, 2010 3:11 am
- 360 GamerTag:H1writer
- Location:Diggi Down Under
Re: How many fans can you put in an Xbox.
depending on what type/size of fans.
you could probably fit about 5-6 35mm ones
you could probably fit about 5-6 35mm ones
Wedgix (custom linux distro): 20% complete
Re: How many fans can you put in an Xbox.
Should I wire them all to the stock fan port or should I use the bottom on the power supply? Is there anywhere else I should wire to?
- humakabula1
- Posts:728
- Joined:Sun May 30, 2010 3:11 am
- 360 GamerTag:H1writer
- Location:Diggi Down Under
Re: How many fans can you put in an Xbox.
not the fan port, that is only made to power 5v specific parts, like the stock 360 fan.
if you try and wire a 12v fan the fuse will blow (rendering the plug useless)
so yes, wire them to the underside of the psu.
if you try and wire a 12v fan the fuse will blow (rendering the plug useless)
so yes, wire them to the underside of the psu.
Spoiler:
Wedgix (custom linux distro): 20% complete
-
- Posts:8
- Joined:Mon Aug 15, 2011 4:15 am
- 360 GamerTag:farsniper1960
Re: How many fans can you put in an Xbox.
how can you tell which part is 12v 5v and ground when looking at any circuit board.
-
- Posts:1000
- Joined:Sat Jan 30, 2010 12:22 am
- PSN Username:Haunted360
- 360 GamerTag:Haunted 360
- Location:Australia
- Contact:
Re: How many fans can you put in an Xbox.
You use a multimeter or oscilloscope.xbox360mod wrote:how can you tell which part is 12v 5v and ground when looking at any circuit board.
Black cable to Ground (-, GND or VEE)
Red cable to Positive (+, V+ or VCC)
Attach those (as seen in the image) and you will see 12 volts on your meter.