Possibly a good way to relocate the power brick

Discuss LEGAL mods for your game systems, and turning them into portables!

Moderator: Moderators

Post Reply
User avatar
stuntpenguin007
Posts: 667
Joined: Sun Apr 27, 2008 12:21 pm

Possibly a good way to relocate the power brick

Post by stuntpenguin007 » Thu Mar 17, 2011 5:45 pm

I'm in the process of building an xbox 360 in a case, and I'm finding it hard to get the power connector soldered to the motherboard off. While I was browsing the internet today, I came across this: http://www.dealextreme.com/p/xbox-360-t ... able-56549" onclick="window.open(this.href);return false;

I think if you cut the cord in half, you could probably solder the wires directly to the xbox 360 motherboard. This would allow you to essentially destroy the power connector on the motherboard, making it easier to get off. By destroy I mean pull apart the connector with pliers so you can desolder each pin one by one.

I might order one of these later if I can find one shipping from the US.
SNESP WIP
Case - 50%
acquired parts - 90%
assembly - 0%

User avatar
humakabula1
Posts: 728
Joined: Sun May 30, 2010 3:11 am
360 GamerTag: H1writer
Location: Diggi Down Under

Re: Possibly a good way to relocate the power brick

Post by humakabula1 » Sat Mar 19, 2011 9:53 pm

what wattage is your iron?
The solder used on the xbox 360 is unleaded, therefore it needs to be heated more in order for it to liquify
Wedgix (custom linux distro): 20% complete

Post Reply