ZN-40 case/N64 trigger buttons question.

Yes it is nice to be able to put your projects INSIDE something isn't it? You know, to hold everything together so it doesn't flop around? Discuss the techniques here!

Moderator:Moderators

Post Reply
Carp
Posts:1
Joined:Mon Jul 30, 2012 2:47 pm
Steam ID:SneakyDakilla
ZN-40 case/N64 trigger buttons question.

Post by Carp » Tue Jul 31, 2012 3:55 pm

So I'm going to get the ZN-40 case most likely, and I want to be able to get trigger buttons on the back, most likely from a ps1 controller which would be two z buttons and the left and right bumpers. So I would need an area that is wide enough to hold those buttons on the back, but I don't think the plastic is wide enough, is their any way I could make it wider because I have seen other people with the same case who have made it wider. So I might have just come up with a solution that might work, by taking the ps1 controller and maybe dremeling off a piece of where the trigger is, sanding it down, and gluing that onto the case. not sure how that would look though.

I want it to look like this.
Image

when originally the case looks like this.
Image

Post Reply