Search found 1505 matches

by Klefmung
Thu Dec 06, 2012 4:14 pm
Forum: 1990's Gaming
Topic: SNES inside a Nomad (Pictures, Progress, and Problems)
Replies: 3
Views: 8100

Re: SNES inside a Nomad (Pictures, Progress, and Problems)

K, looking just now, the middle pins on the bottom 3 rows arent connected to anything. The pins at the top were always disconnected when on the SNES side because the top ones put it on the NES side. The ones in the middle, I dunno about. I will do further investigating.
by Klefmung
Sat Dec 01, 2012 12:23 pm
Forum: 1990's Gaming
Topic: SNES inside a Nomad (Pictures, Progress, and Problems)
Replies: 3
Views: 8100

SNES inside a Nomad (Pictures, Progress, and Problems)

Well, here's the money shot: http://imageshack.us/a/img534/1636/image12012012121248.jpg The back: http://imageshack.us/a/img836/4396/image12012012121543.jpg (cart slot hole still needs to be cut, but it will wind up sticking out the back) And those button contacts for the shoulders are from R1 and L...
by Klefmung
Sat Nov 17, 2012 10:53 pm
Forum: 1990's Gaming
Topic: The dangly part on the retro duo board
Replies: 2
Views: 6920

The dangly part on the retro duo board

Hey, I was wondering about the protrusion on the corner of the retro duo board around where the power switch is. would it be possible to remove that portion? I mean, I know it should be, I just don't know if it has been done yet. And if there is confirmation on the feasibility of that, I'd rather no...
by Klefmung
Sat Jan 07, 2012 6:16 pm
Forum: Forum 42
Topic: Hmm. Howdy!
Replies: 39
Views: 24128

Re: Hmm. Howdy!

gannon wrote:
bicostp wrote:It's quiet.


Too quiet...
I can let bots start posting more often again, would that liven things up? :twisted:
*peers down at signature* So not much has changed! Good.
by Klefmung
Fri Jan 06, 2012 10:42 pm
Forum: Forum 42
Topic: Hmm. Howdy!
Replies: 39
Views: 24128

Re: Hmm. Howdy!

Familiar? I thought I was a complete stranger! XD
by Klefmung
Thu Jan 05, 2012 12:35 am
Forum: 2000's Gaming
Topic: Controller port and wired in controls together?
Replies: 2
Views: 2390

Re: Controller port and wired in controls together?

Yes and yes. just place a switch to switch power between the port and the imbedded controls. and for video, you can just hook up video to a port and to the screen at the same time.
by Klefmung
Tue Jan 03, 2012 6:18 pm
Forum: Forum 42
Topic: Hmm. Howdy!
Replies: 39
Views: 24128

Re: Hmm. Howdy!

It has been quiet... at least quieter than back in aught six.....
by Klefmung
Mon Jan 02, 2012 1:02 pm
Forum: Case Construction
Topic: vac formed case woes
Replies: 1
Views: 4691

vac formed case woes

So, I vacuum formed for the first time. I have issues like not being able to cut the case out cleanly. I am okay with not being able to use the whole depth since I have two halves to put together. Mainly, I just need clean edges on either side. The problem here is that I dont have a dremel. How woul...
by Klefmung
Mon Jan 02, 2012 12:23 am
Forum: 1990's Gaming
Topic: 2 Controllers Into 1
Replies: 40
Views: 13545

Re: 2 Controllers Into 1

I guess the amount of wires is really important. What I was thinking port wise was the necessity of opening up a dead SNES to grab the ports, then an outside controller to hack off the plug to go into the SNES. This would be easier if you had all that, I spose. Two options, different challenges, sam...
by Klefmung
Sun Jan 01, 2012 2:16 pm
Forum: 1990's Gaming
Topic: 2 Controllers Into 1
Replies: 40
Views: 13545

Re: 2 Controllers Into 1

I was thinking more along the lines of a little box (with just the IC, really) which sent out from all angles. I mean, some sort of box would have to be involved anyhow. Like, have your two controllers, open them both up, and take the ICs out, then stick one of the ICs in a little box, with all the ...
by Klefmung
Sun Jan 01, 2012 3:27 am
Forum: 1990's Gaming
Topic: 2 Controllers Into 1
Replies: 40
Views: 13545

Re: 2 Controllers Into 1

I posted a reply, but it isn't showing up. How strange. Why dont you just wire the controllers together on the other side of the chip? send one set of signals straight to the SNES, then just send each button signal and a common ground to both controllers... then it will be like there is one controll...
by Klefmung
Sun Jan 01, 2012 3:21 am
Forum: 1990's Gaming
Topic: 2 Controllers Into 1
Replies: 40
Views: 13545

Re: 2 Controllers Into 1

Why dont you just wire the controllers together on the other side of the chip? send one set of signals straight to the SNES, then just send each button signal and a common ground to both controllers... then it will be like there is one controller on the SNES side, except two places (in two different...
by Klefmung
Fri Dec 30, 2011 6:40 pm
Forum: 2000's Gaming
Topic: Cut down disc drive dimensions?
Replies: 0
Views: 2050

Cut down disc drive dimensions?

Hey, I know wiikey fusion/wode is kind of "The wave of the future," but I want to challenge myself and see how well I can do with the dang ol' DD. It will also allow me to play the physical form of those precious games I spent my preteen years collecting. So, jumping in the proverbial time machine, ...
by Klefmung
Tue Jan 13, 2009 6:56 pm
Forum: Forum 42
Topic: Cennar
Replies: 92
Views: 6655

khaag wrote:I do. You're the MMA guy, no?

Man, this is like an ancient member reunion!
Wow, I was known for MMA? Weird... >_> I guess I wasn't known for my mods since I didn't have a digital camera in those days... well, yea, I am the mma guy, and still doing it. my hair is much longer though.
by Klefmung
Sun Jan 11, 2009 11:28 pm
Forum: Forum 42
Topic: Cennar
Replies: 92
Views: 6655

Hey, I remember you... but I bet NO ONE remembers me...