Hi guys,

This is probably my best work to date (it definitely gets easier with every portable).

Please take a look. Thanks.

http://www.benheck.com/phpBB/viewtopic.php?t=15584

Jeff S.

May I be the first to congratulate you on a very nice job. Cosmetically, the thing is set up very nicely, and it's probably as small as you can make that arcade unit, no doubt about that.

May I make a suggestion, though? If you want that paint to last on plexiglass, I highly recommend roughing it up with sandpaper, putting on a coat or two of primer, THEN adding a few, light, segmented coats of paint. It'll look better in the end, and for your sake, last a lot longer as well.

Again, great job, and here's to seeing more of these arcade portables in the future! AYE!

CTFan

Nice job! I think that's the first time that I've seen a PSone screen used vertically. Did you use the RGB signals from the MX5000 board? That PCB is really small.

Thanks Marshallh, yup the that the beauty of "Jamma" the RGB comes right off of it.

Jeff

Overall it's perfect, but I think you'll encounter problems with the way you cut the d-pad hole