Well I like really really need to build this thing for a guy...

It's kinda embarassing

But when I lost the ability to cut sidewalls a lot of my projects just got stuck in limbo. Including some handhelds I had to build.

But that's past me now I finished the Sega Genesis and so now I need to finish the Sega Dreamcast.

I have the sidewalls (or most of them)
I now have a reliable way to get the plates cut (and future sidewalls from 3/8" clear acrylic)
I have the dreamcast
I need to buy a 10 ohm resistor to fix controller port 1
I have the controller.
I have the batteries
I have the screen (and have supplies needed to mod it)

I'm going to order the case plates. And Hot glue it all together Sound good?

It's going to look similar to the one in my sig except it's black and doesn't go in on the bottom.

Buy a bulk package of resistors at Radioshack. You can get a 500-piece assortment of every resistance you'll ever need for around $15.

Yep... that's were I'm heading after work. But I'm just going to get the pack

Okay here's a before picture.


And this is after. And yes it did work!


Sent from my HTC Hero CDMA via Tapatalk

And I managed to contact the comissioner
Which is always good.
I expected the quote for the plates yesterday... but oh well. Next thing on the list is to start removing stuff from the dreamcast and wire up the pico PSU

"It's Okay... we're making out now..."

Okay the comissioner has given me the go on the dreamcast... I'm off to the basement to mod the picoPSU

Okay a fresh start. Here's everything.


Ill use this controller because its small...


I'm using this joystick.


And this dpad...


Herts there batteries. I might do something different because they're super heavy


And of course this screen.


Sent from my HERO200 using Tapatalk

I just got word from the engraving shop. They said $25 bucks for each piece I need cut.

Backplate
Frontplate
Screen Backplate (the lid part)
Screen Front Plate

And I might need them to cut out the sidewalls...

I gave them the go so here we go!

i would use lithium polymer batteries instead of the big heavy cells.

Can you provide a link? How hard is it to charge them? I just need 12v


Sent from my iPod touch using Tapatalk

eh nevermind i just looked up the prices... you might be better off working the pack you have.

The Dreamcast runs of 7.4v just fine on the 12v line. Use 2 of the 4700 mAh Li-Po's in my guide and you're much better off.

viewtopic.php?f=43&t=34576

Are you serious? Maybe I shouldnt use the picopsu? I have two of the regulators commonly used for. The n64. So what do I need 7.4, 5 & 3 volts?

On a side note I found the sidewall pieces I had cut earlier... Ill probably need a few more cut though...

Sent from my HERO200 using Tapatalk

A 7.4v battery and a 7805 regulator for the 5v and a Ti PTH08080WAH or PTH08000 regulator for the 3.0v.

Or use a switching regulator for the 5v for less heat.

I mine-as-well use another of the switching regulators since I have them... what resistor combination would I use to get 5 volts out of it?

Oh and good news! The Engraving Shop has my order ready!

Now that's what I call service!

Will have pics later tonight.

Willl have pics on Friday or Saturday... (can't get out of work early )