broken rcp pin
Moderator:Moderators
- frenchfries
- Posts:7
- Joined:Fri Feb 17, 2012 4:23 pm
- PSN Username:antoinegarez
- Location:The Great North aka Saskatchewan
Hello people, while I was doing the rcp wiring one of the pins broke off (pin 51 of the rcp) . According to this site http://www.crazynation.org/N64/n64_cart_info.htm the pin is AD2, is there any other place I can get AD2 from?. (I know this is kind of a stupid question because it goes through the chip, but i'm desperate )
Satisfaction guaranteed....most of the time
- jjhammerstein
- Senior Member
- Posts:1562
- Joined:Tue Nov 18, 2008 7:15 pm
- Location:Southern CT
- Contact:
- frenchfries
- Posts:7
- Joined:Fri Feb 17, 2012 4:23 pm
- PSN Username:antoinegarez
- Location:The Great North aka Saskatchewan
Re: broken rcp pin
Darn, but whatever. I was just wondering, is the flux for copper pipes the same stuff as for electrical wires?
Satisfaction guaranteed....most of the time
-
- Posts:1000
- Joined:Sat Jan 30, 2010 12:22 am
- PSN Username:Haunted360
- 360 GamerTag:Haunted 360
- Location:Australia
- Contact:
Re: broken rcp pin
Eh, you can fix it. You will need to scrape off the silicon just enough so you can solder to it.
Not easy, and if you cant solder at a 0.5 mm pitch on quad flat packages, then there is no point trying.
Not easy, and if you cant solder at a 0.5 mm pitch on quad flat packages, then there is no point trying.