I'm currently building a portable NES and wanted to use the original Power and Reset switches. The reset works fine but the power switch doesn't. I'm guessing it has to do with the two pins I'm not using for where the RF Box used to be.
Is there something I have to do in order to use the original power and reset buttons? Thanks in advance.
NES Modification: Using original Power/Reset switches
Moderator:Moderators
Re: NES Modification: Using original Power/Reset switches
RedSeven4 wrote:I'm currently building a portable NES and wanted to use the original Power and Reset switches. The reset works fine but the power switch doesn't. I'm guessing it has to do with the two pins I'm not using for where the RF Box used to be.
Is there something I have to do in order to use the original power and reset buttons? Thanks in advance.
Since you said your reset button was still functioning, I'm going to assume that your power/reset buttons are still installed on their little chunk of PCB. If that is the case, then this couldn't be easier. Look at the 5 wires coming off of the little board your power/reset buttons are on. There's a white one, a red one, a brown one, a yellow one, and an orange one. They're numbered, too. 5,2,1,4,3 respectively. So what you want to do is take your brown wire and red wire, and cut them off where they go into the blue plug that plugs into the motherboard. Solder the brown wire to the spot you currently have your positive wire going to (where the RF box used to be.) Then connect the red wire to the positive terminal of whatever you are using for a power source (battery, or whatever.) If you did everything right, then your original power switch should work just like it used to, and your reset button should still be working also.
Re: NES Modification: Using original Power/Reset switches
Did that work out for you? If so, I'm going to do more or less the same thing in one of my current projects.