Hey guys, making a portable n64 and had a couple questions about batteries for the board and screen.
Ok I am running a 7" lcd 4:3 screen that runs off of 12v..
So here is what I had planned
the batteries are super small 3.7V 650mah lipos.. they are wired in sets of 3 in series.. totalling 11.1v and 4 of those packs are wired in parallel
1. My question is first of all will this work? i don't see any problems with it unless i am missing something?
2. Second, will 1 pcboard work for charging all batteries at 11.1v and are lipos an issue with charging?
3. The last question I have is what is the approximate total run time of this setup pushing to the 12v 7" lcd 4:3 screen and n64 board?
Any help here would be amazing. I have zero electronics knowledge so i'm looking for some help from anyone with experience on this. Thank you in advance!
Need battery help on portable n64
Moderator:Moderators
Re: Need battery help on portable n64
Where did you find a 7" 4:3 lcd? I am having trouble locating one. I assume it runs at 640x480?
-
- Posts:257
- Joined:Sat Feb 05, 2011 8:18 pm
Re: Need battery help on portable n64
You only need 7.4 volts on the 12V line. Saves batteries. Instead of of using sets of three in series, use sets of two.
EDIT: I see your screen needs 12V. I'd recommend a smaller screen anyway, but if you need 12V, disregard what I said.
EDIT: I see your screen needs 12V. I'd recommend a smaller screen anyway, but if you need 12V, disregard what I said.
ShockSlayer wrote:Proggy's right.
ttsgeb wrote:mfw prog was not only right, but 100% so.